DYZEDESIGN DyzEND-X Hotend 1.75mm 12 V DDK-00031

Fast Prints

The aluminum melt block transfer heat very quickly to the nozzle for an efficient and very fast printing speed. Furthermore, the long melt zone can handle very high filament feed without any trouble.

Titanium Transition Tube

A titanium alloy has been meticulously chosen to provide both stiffness and low thermal conductivity, limiting heat losses to the cold side.

High Temperature

The high temperature sensor used inside the DyzEnd-X enable precise readings up to 500°C. Any thermoplastics can be used with the DyzEnd-X. With 12v its maximum 420 °C possible.

All Metal Melt Zone

The heated zone is made entirely from metals which can withstand very high temperature before losing mechanical properties. Even the sensors and heaters are protected by high temperature resistant sleeves.

DyzEnd-X HotEnd Wear resistant nozzle

The DyzEnd-X comes built in with high wear resistant nozzle. The performance have been measured and tested.

Cold Swappable Nozzles

By using a very special high temperature sealing washer, the DyzEnd-X is able to switch nozzles at room temperature. No leaks, no burning hazard.

DyzEnd-X HotEnd Flexible Filament Ready

The filament is very well guided inside the DyzEnd-X, which allows very high speed with flexible filament.

Jam Free

The DyzEnd-X perform very well in retraction. The secret is its manufacturing process which enable very low friction inside the tube.

DyzEnd-X HotEnd High Resolution Sensor

The unique high temperature sensor has a resolution of 0.16°C at 210°C which is better than a amplified RTD sensor and a thermocouple.

Assembled and Tested

The DyzEnd-X is a high-end product and comes preassembled and tested avoiding the user to have any trouble receiving substandard part that are hard to assemble or fit together.

DyzEnd-X HotEnd Connectors

The DyzEnd-X comes with connectors for each electrical component so you can easily maintain it.

Sealing washer

The sealing washer ensure a leak-free operation and makes it easier to switch nozzles.

DyzEnd-X HotEnd Liquid Cooling Ready

The DyzEnd-X can be easily converted to a liquid cooled setup with Dyze Design’s specialized cooling blocks.

Bowden Ready

The DyzEnd-X is compatible with a M8x1.25 push to connect fitting. The 4mm PTFE tube can be inserted through the connector and guides the filament as far as possible inside the hotend.

Groove Mount

The hotend mounting mechanism is based on the form factor called “Groove Mount”. The 12mm groove makes it very easy to switch and maintain your hotend and nozzle.

DyzEnd-X HotEnd Small Form Factor

By using a low conductivity transition tube, the DyzEnd-X is designed very small. This enables you to use your build volume more efficiently.

Fast heating

The DyzEnd-X can heat very quickly. In only 70 seconds, it reaches 210°C.

Any Plastics

The DyzEND-X prints all types of plastics:
Standard: PLA, ABS
Flexible: TPE, TPU
Support: PVA, HIPS
Advanced: PC, PET, PETE, PETG, NYLON
Engineering: PEEK, PEI
Metal powder filled
Wood filled
Carbon fiber filled

In the box

DyzEnd-X with Fan with connector
Heater with Connector 12v 45 W
Temperature Sensor with Connector up to 500°C
Wear resistant Nozzle 0.4mm

Extension Cables
1000mm – Fan
1000mm – Heater
1000mm – Sensor