PrintaClean - 250ml
CHF 7.20 incl. VAT
Available immediately
Sometimes 3D prints and adhesives can leave nasty residue on the build plate.
PrintaClean is a powerful solvent to effectively remove this sticky residue from the build plate with ease so the next creation can start on a clean slate. The 250ml last for a lot of clean ups.
Instructions
Make sure to spray only a build plate that has cooled off. Then remove the build plate from the 3D printer and spray a good amount of solution on it. Let the solution sit for 20-30 seconds to loosen the residue. Wipe off with a paper towel.
Repeat if necessary or allow for a longer exposure time.
PrintaClean is a powerful solvent to effectively remove this sticky residue from the build plate with ease so the next creation can start on a clean slate. The 250ml last for a lot of clean ups.
Instructions
Make sure to spray only a build plate that has cooled off. Then remove the build plate from the 3D printer and spray a good amount of solution on it. Let the solution sit for 20-30 seconds to loosen the residue. Wipe off with a paper towel.
Repeat if necessary or allow for a longer exposure time.
| Item no. | 01900617.4 |
| Barcode | 9120078080153 |
| Manufacturer | 3DWare.ch Handelsware |
| Stock | 116 pcs |
